• 1 – 20 t/h
  • 0.7 – 2 Mpa
  • Industrial
  • In Stock
  • Nature gas, coke oven gas, biogas, methanol, liquid propane gas, diesel, heavy oil, light oil, crude oil, etc.
  • Heat supplying, chemical, food, textile, printing and dyeing, cigarettes and tobacco, fodder, pharmacy, building materials, brewery, rubber, hospital etc.

WSN series gas / oil fired industrial horizontal steam boiler is a kind of safety and high efficiency heating equipment with fully automatic intelligent control system. It’s a boiler shell type 3 passes wetback oil/gas fired boiler. Usually, the WNS series steam boilers widely used for industry production and processing, such as textile mill, medicine industry, food & beverage industry, chemical industry, garment industry, food processing industry, and wood processing industry, moreover, it could be used for central heating in enterprise, hotel, hospital, civil architecture, etc.

Main Condenser - Steam Condenser - nuclear-power.n

2019-9-13 · Surface Condenser. The pressure inside condenser is given by the ambient air temperature (i.e. temperature of water in the cooling system) and by steam ejectors or vacuum pumps, which pull the gases (non-condensibles) from the surface condenser and eject them to the atmosphere. The pressure inside condenser determines the overall power output of the power conversion system.

SELECTION OF THE OPTIMAL EXTRACTION PRESSUR

2017-3-12 · proportional to the temperature difference t,, - t, (Fig. 2). For maximum boiler steam flow and the control element R in the fully open position, the turbine steam-extraction pressure Ptd allows water heating to the temperature fowd through the temperature difference At,, = t owd - fwd (Fig. 2).

If the pressure in a steam boiler 3.6 bar what is th

If the pressure in a steam boiler 3.6 bar what is the temperature of the steam? in the condenser. Gland steam pressure is to supply at about 0,2 bar. is the same as atmodpheric pressure

Surface condenser - Wikiped

2019-9-7 · A surface condenser is a commonly used term for a water-cooled shell and tube heat exchanger installed to condense exhaust steam from a steam turbine in thermal power stations. These condensers are heat exchangers which convert steam from its gaseous to its liquid state at a pressure below atmospheric pressure.Where cooling water is in short supply, an air-cooled condenser is often

AREN 2110: Thermodynamics Spring 2011 HOMEWOR

2011-4-14 · 2. (4 points, 2 per part) A Rankine cycle with refrigerant (R-134a) as the working fluid is to be used to produce work with heat added from a lower temperature source than a steam power cycle. The boiler pressure is 1.6 MPa and the condenser pressure is 0.4 MPa. The temperature of the R-134a at the turbine inlet is 80 oC, and the quality at the

Steam Pressure Of Reboiler - Student

Steam Pressure Of Reboiler - posted in Student: Hi, I have a question about distillation reboiler, i was asked to tell what will happen if we increase a steam pressure of reboiler from 10 psig to 12 psig, and run the experiment at total reflux? using the temperature data i have seen that temp. of the middle trays going down as steam pressure go up, reflux temp and condenser temp goes up, Why

Condition Monitoring of Steam Turbines b

Condition Monitoring of Steam Turbines by Performance Analysis. Author: Ray Beebe, Condenser pressure is largely a function of seasonal conditions and weather, and is usually taken at the best attainable on the day. P1, T1 etc are steam pressure and temperature measured at points of extraction flows in superheated sections.

Study the Performance of the Combined Gas Turbin

2013-1-29 · optimum bled steam temperature ratio is found at 0.4 with single f.w.h at given working conditions. Similarly the optimum pressure in a steam reheated is obtained at 20– 25% of the boiler pressure irrespective of the number of heaters. The results show that the maximum gain

The boiler pressure is 38bar and the condense

2019-9-13 · The boiler pressure is 38bar and the condenser pressure 0.032 bar.The saturated steam is superheated to 420 oC before entering the turbine. a) Calculate the cycle efficiency of the Rankine cycle. b) Calculate the work ratio of the Rankine cycle.

Optimization of a Condenser in a Thermal Power Pla

2015-4-10 · 2-3, steam boiler, the glow of the evaporation occurs at constant pressure, 3-4, steam entering to the turbine, expands isentropic, At the 4-1, at the constant pressure, heat is thrown out, [7]. E Figure 2 >Scheme of power plant steam turbine [5] outlet temperature and pressure T 3 and P 3, respectively, also condenser pressure is shown by P o

A steam power plant operates on a kPa in the boile

2019-8-21 · A steam power plant operates on a kPa in the boiler and condenser, respectively. Due to the metallurgic limits in fabrication of the turbine blades, the maximum temperature in the cycle is

ModelRated steam capacity(t/h)Rated working pressure(Mpa)Rated steam temperature(℃)Maximum transport size(m)
(L×W×H)
WNS1-0.7-Y(Q)10.71703.3×1.8×2.1
WNS1-1.0-Y(Q)111843.3×1.8×2.1
WNS1.5-1.0-Y(Q) 1.511843.0×1.8×2.0
WNS1.5-1.25-Y(Q)1.51.251943.0×1.8×2.0
WNS2-1.0-Y(Q) 211844.4×2.1×2.5
WNS2-1.25-Y(Q)21.251944.4×2.1×2.5
WNS3-1.0-Y(Q)311844.6×2.3×2.6
WNS3-1.25-Y(Q)31.251944.6×2.3×2.6
WNS4-1.25-Y(Q)41.251944.7×2.5×2.9
WNS4-1.6-Y(Q)41.62044.7×2.5×2.9
WNS5-1.25-Y(Q)51.251945.3×2.7×3.3
WNS5-1.6-Y(Q)51.62045.3×2.7×3.3
WNS6-1.25-Y(Q)61.251945.9×2.6×3.0
WNS6-1.6-Y(Q)61.62045.9×2.6×3.0
WNS8-1.25-Y(Q)81.251945.9×2.8×3.1
WNS8-1.6-Y(Q)81.62045.9×2.8×3.1
WNS10-1.25-Y(Q)101.251947.7×2.8×3.1
WNS10-1.6-Y(Q)101.62047.7×2.8×3.1
WNS15-1.25-Y(Q)151.251947.0×3.1×3.6
WNS15-1.6-Y(Q)151.62047.0×3.1×3.6
WNS20-1.25-Y(Q)201.251948.3×3.4×4.0
WNS20-1.6-Y(Q)201.62048.3×3.4×4.0