• 1 – 20 t/h
  • 0.7 – 2 Mpa
  • Industrial
  • In Stock
  • Nature gas, coke oven gas, biogas, methanol, liquid propane gas, diesel, heavy oil, light oil, crude oil, etc.
  • Heat supplying, chemical, food, textile, printing and dyeing, cigarettes and tobacco, fodder, pharmacy, building materials, brewery, rubber, hospital etc.

WSN series gas / oil fired industrial horizontal steam boiler is a kind of safety and high efficiency heating equipment with fully automatic intelligent control system. It’s a boiler shell type 3 passes wetback oil/gas fired boiler. Usually, the WNS series steam boilers widely used for industry production and processing, such as textile mill, medicine industry, food & beverage industry, chemical industry, garment industry, food processing industry, and wood processing industry, moreover, it could be used for central heating in enterprise, hotel, hospital, civil architecture, etc.

What is Boiler Hydrostatic Test in Thermal Power Plant

Boilers in thermal power plants work at high pressures and temperature. Hydrostatic tests are mandatory as per boiler regulations to test the integrity of all the parts and joints in a boiler. Water and hydrostatic pumps are used to carry out the test. This article gives a brief on the hydrostatic test principles. Hydrostatic tests are also done on all types of pressure vessels.

What is the pressure of steam in a thermal powe

It's all depends on capacity of power plant as I had knowledge of some power plants is 150MW CFBC boiler 137ksc MS pressure 250MW PF boiler 150ksc is MS pressure 600MW PF boiler(sub critical) 180ksc is MS pressure 660MW Pf boiler super critical 23

Thermal Power Plant, Exergy, Energy, Efficiency

thermodynamic analysis of a Rankine cycle reheat steam power plant was carried out to study the energy and exergy efficiencies at d ifferent operating conditions of boiler temperature, boiler pressure, mass fraction ratio and work output from the cycle[4]. Exergy and cost balances have been used to study gas-turbine cogeneration system[10].

Energy and Exergy Analysis of 210 MW Jamshor

Energy and Exergy Analysis of 210 MW Jamshoro Thermal Power Plant main steam pressure and main steam temperature are nominated as operating parameters. Energy and Exergy Analysis of 210 MW

ANALYSIS OF USING EXHAUST FLUE GAS FOR POWE

2018-4-21 · heat of the flue gas is used in this project to hea t the feed water of the boiler. That the heat of the flue gas is used in the condensate system. That one of the low pressure heater (LPH) is replaced by the flue gas heater. So the efficiency of the thermal power plant will be improved and the energy used by the power plant will be reduced.

design of boiler of thermal power stati

Thermal Power Plant : Principle, Parts, Working. Today we will learn about thermal power plant, its main components along with working and its advantages and disadvantages. Steamcturbine power plant which is sometime known as coal based power plant or thermal power plant, is a major source of electrical energy for any country.

Energy and Exergy Analysis of a Coal Fired Boiler o

destruction occurs due to combustion process. V. D. Shimpi and M. Yadav [6] in an energy and exergy analysis of boiler of 210MW coal based thermal power plant found the energy and exergy efficieny as 73.96% and 39.85% and concluded that exergy destruction increases with increasing reference temperature. S. J.

THERMODYNAMIC ANALYSIS OF GANDHINAGA

2012-10-23 · Stations units Gandhinagar Thermal Power Station, Wanakbori Thermal Power Station, Utran GBPS & Dhuvaran Combined Cycle Power Plant (CCPP) till the complete unbundling of erstwhile GEB was undertaken upto 31st March 2005. The Gandhinagar Thermal Power Station is located at Gandhinagar, the capital of Gujarat near Ahmedabad.

Exergy Analysis of 210 Mw of Vijayawada Thermal Powe

2015-12-29 · Exergy Analysis of 210 Mw of Vijayawada Thermal Power Station (V.T.P.S) N. Naga Varun components of a 210 MW thermal power plant has been performed and the results show that the exergy destruction Boiler is an enclosed vessel in which water is heated and circulated until the water gets converted into steam

Exergy Analysis of 4.5mw Biomass Based Steam Power Pla

2013-10-15 · analysis performed on a 4.5MW steam power plant in Karempudi.The results of the exergy analysis indicate that the boiler produces the highest exergy destruction .Exergetic efficiency is compared with Thermal Efficiency(based on Energy) and it is observed that thermal efficiency of the plant about 18.25%andexergeticefficiencyis 16.89%. Keywords

Analysis of Regenerative System in Steam Power Pla

2015-8-11 · be operated at maximum level of efficiency. In case of thermal power plants this applies equally to all its auxiliaries. The feed water heaters form a part of the regenerative system to increase the overall thermal efficiency of the plant. In the operation and maintenance of a power plant the feed water

ModelRated steam capacity(t/h)Rated working pressure(Mpa)Rated steam temperature(℃)Maximum transport size(m)
(L×W×H)
WNS1-0.7-Y(Q)10.71703.3×1.8×2.1
WNS1-1.0-Y(Q)111843.3×1.8×2.1
WNS1.5-1.0-Y(Q) 1.511843.0×1.8×2.0
WNS1.5-1.25-Y(Q)1.51.251943.0×1.8×2.0
WNS2-1.0-Y(Q) 211844.4×2.1×2.5
WNS2-1.25-Y(Q)21.251944.4×2.1×2.5
WNS3-1.0-Y(Q)311844.6×2.3×2.6
WNS3-1.25-Y(Q)31.251944.6×2.3×2.6
WNS4-1.25-Y(Q)41.251944.7×2.5×2.9
WNS4-1.6-Y(Q)41.62044.7×2.5×2.9
WNS5-1.25-Y(Q)51.251945.3×2.7×3.3
WNS5-1.6-Y(Q)51.62045.3×2.7×3.3
WNS6-1.25-Y(Q)61.251945.9×2.6×3.0
WNS6-1.6-Y(Q)61.62045.9×2.6×3.0
WNS8-1.25-Y(Q)81.251945.9×2.8×3.1
WNS8-1.6-Y(Q)81.62045.9×2.8×3.1
WNS10-1.25-Y(Q)101.251947.7×2.8×3.1
WNS10-1.6-Y(Q)101.62047.7×2.8×3.1
WNS15-1.25-Y(Q)151.251947.0×3.1×3.6
WNS15-1.6-Y(Q)151.62047.0×3.1×3.6
WNS20-1.25-Y(Q)201.251948.3×3.4×4.0
WNS20-1.6-Y(Q)201.62048.3×3.4×4.0