WSN series gas / oil fired industrial horizontal steam boiler is a kind of safety and high efficiency heating equipment with fully automatic intelligent control system. It’s a boiler shell type 3 passes wetback oil/gas fired boiler. Usually, the WNS series steam boilers widely used for industry production and processing, such as textile mill, medicine industry, food & beverage industry, chemical industry, garment industry, food processing industry, and wood processing industry, moreover, it could be used for central heating in enterprise, hotel, hospital, civil architecture, etc.
2017-6-28 · The information you provide is necessary only for the administration of the programs as required by the Alberta Safety Codes Act and Regulations in the Pressure Equipment Discipline. In this space, show facsimile of manufacturer's logo or trademark as it will appear on the fitting.
The "Pressure Vessels" section of the B-51 code identifies pressure vessels and their installation, including pressure vessel inspection openings. This section also shows the design of cushion tanks, blow-off vessels, and the installation of: Select one: A. Air receivers. B. Blowdown tanks. C. Boiler drums. D. Fuel tanks. E. Dearators.
2015-1-21 · The task force will include individuals who represent; Alberta Municipal Affairs, ABSA, owner/end users and manufacturers. Expertise is required in the areas of design/engineering, fabrication, in-service inspection and pressure vessel records. The task force will report to the Boilers and Pressure Vessels Technical Council.
2019-9-13 · ASME - International Boiler and Pressure Vessel Code The International Boiler and Pressure Vessel Code establishes rules of safety governing the design, fabrication, and inspection of boilers and pressure vessels, and nuclear power plant components during construction
Under Alberta's Safety Codes Act and Pressure Welder Regulation, you must hold an appropriate certificate from the Alberta Boilers Safety Association (ABSA) and a performance qualification card to weld on pressure vessels, boilers, pressure piping systems or fittings. There are three types of certificates: (1) Grade B Pressure Welder, (2) Grade C Pressure Welder, and (3) Machine Welding
3 sr 61/78 welding of boilers, pressure vessels and pressure piping saskatchewan regulation 61/78 the boiler and pressure vessel act regulations respecting the Pressure vessel – Wikipedia A pressure vessel is a container designed to hold gases or liquids at a pressure substantially different from the ambient pressure.
2018-3-6 · (1) These regulations apply to all steam and hot water boilers, pressure vessels, heat exchangers, air receivers, pressure plants, pressure piping systems, compressed gas systems and other pressure vessels or fittings referred to in the Act or defined in these regulations and to all power engineers, refrigeration and compressor operators
2019-8-22 · (2) The following boilers and pressure vessels do not require an inspection/certification permit under section 6 of the Boilers and Pressure Vessels Regulation (AR 293/94) if they meet the requirements of the A.S.M.E. Boiler and Pressure Vessel Code or CSA B51 Boiler, Pressure Vessel and Pressure Piping Code:
2016-12-10 · MINUTES: Boilers & Pressure Vessels Technical Council Meeting – May 9, 2014 Page 3 The regulatory interpretation is fairly straight forward. As over pressure protection has been a regulationrequirement dating back to at least 1975, requiring over pressure protection compliance by pressure relief devices (or through other means
2019-9-9 · Effective April 26, 2016, under Ministerial Order M 147 deposited as B.C. Reg. 97/2016 (attached to this information bulletin), the schedule to the Power Engineers, Boilers, Pressure Vessel and Refrigeration Safety Regulation has been amended as set out in the table below.
2019-8-23 · Technical Safety Act - Province Streamlines Safety Regulations in New Act . New regulations covering boilers and pressure equipment, fuel safety, crane operators, power engineers, standards, general matters and fees will take effect on April 1, 2011 Read More. Boiler and Pressure
Model | Rated steam capacity(t/h) | Rated working pressure(Mpa) | Rated steam temperature(℃) | Maximum transport size(m) (L×W×H) |
WNS1-0.7-Y(Q) | 1 | 0.7 | 170 | 3.3×1.8×2.1 |
WNS1-1.0-Y(Q) | 1 | 1 | 184 | 3.3×1.8×2.1 |
WNS1.5-1.0-Y(Q) | 1.5 | 1 | 184 | 3.0×1.8×2.0 |
WNS1.5-1.25-Y(Q) | 1.5 | 1.25 | 194 | 3.0×1.8×2.0 |
WNS2-1.0-Y(Q) | 2 | 1 | 184 | 4.4×2.1×2.5 |
WNS2-1.25-Y(Q) | 2 | 1.25 | 194 | 4.4×2.1×2.5 |
WNS3-1.0-Y(Q) | 3 | 1 | 184 | 4.6×2.3×2.6 |
WNS3-1.25-Y(Q) | 3 | 1.25 | 194 | 4.6×2.3×2.6 |
WNS4-1.25-Y(Q) | 4 | 1.25 | 194 | 4.7×2.5×2.9 |
WNS4-1.6-Y(Q) | 4 | 1.6 | 204 | 4.7×2.5×2.9 |
WNS5-1.25-Y(Q) | 5 | 1.25 | 194 | 5.3×2.7×3.3 |
WNS5-1.6-Y(Q) | 5 | 1.6 | 204 | 5.3×2.7×3.3 |
WNS6-1.25-Y(Q) | 6 | 1.25 | 194 | 5.9×2.6×3.0 |
WNS6-1.6-Y(Q) | 6 | 1.6 | 204 | 5.9×2.6×3.0 |
WNS8-1.25-Y(Q) | 8 | 1.25 | 194 | 5.9×2.8×3.1 |
WNS8-1.6-Y(Q) | 8 | 1.6 | 204 | 5.9×2.8×3.1 |
WNS10-1.25-Y(Q) | 10 | 1.25 | 194 | 7.7×2.8×3.1 |
WNS10-1.6-Y(Q) | 10 | 1.6 | 204 | 7.7×2.8×3.1 |
WNS15-1.25-Y(Q) | 15 | 1.25 | 194 | 7.0×3.1×3.6 |
WNS15-1.6-Y(Q) | 15 | 1.6 | 204 | 7.0×3.1×3.6 |
WNS20-1.25-Y(Q) | 20 | 1.25 | 194 | 8.3×3.4×4.0 |
WNS20-1.6-Y(Q) | 20 | 1.6 | 204 | 8.3×3.4×4.0 |